Prosystemaqua - Controller Plus - PH & EC - 4 Pumps

Continuous flow pH / EC controller

Ensures that pH / EC are always at the right value.
Indicates pH / EC values and continuously regulates, for pre-adjustment cis
Controls automatic filling of tanks, recirculation pump, irrigation pump and water temperature.

Prosystemaqua Control Plus information:

• Works with multiple systems: Hydroponics, aeroponics. Aquarium or vertical flow.
• Pumps are independently controllable: Flow rates from 0 to 4 L/h.
• 2 independent irrigation programs: Irrigation pump and water recirculation pump.
• A heating or cooling system can be connected to control water temperature.
• Automatic water filling triggered by a probe activating the filling solenoid valve.
• The controller is mounted on a methacrylate plate, where the water inlet and recirculation pump outlet can be connected.
• The impurity filter maintains the accuracy of the pH /EC probes.

Operation :

The controller requires configuration before operation

• pH:
  Enter the desired value in the water container.
  Program the pH mode to "down" or "up".
  Perform calibration.
  Adjust the proportional flow rate of the pH pump.
  
  
• EC PUMP:
  Enter the desired EC value in the water container.
  Check temperature compensation, as well as time and air alarms.
  Proceed with calibration.
  Adjust proportional flow for pumps A and b.
  

• Water recirculation:
  Once the water recirculation pump is connected to the controller, program the desired sequences and times.
  
  
• Irrigation system:
  Once the irrigation pump irrigation pump connected to the controller, program the desired sequences and times.
  
  
• Filling system:
  The level sensor is positioned in the water tank.
  
  
• Temperature control:
  Once the cooling or heating system is connected to the controller, set the desired water temperature.

• PH measurement and conductivity:
  The probe allows detection of conductivity and determines the value, transmitting it to the display of each pump.
  
  
• Fertilizer suction and pH control:
  The controllers inject the product into the suction filter, and regulate pH and EC.
  
  
• Fertilizer injection:
  Once the EC and pH values have been set in the controller, fertilizer and pH are distributed via the manifold injection valves, adjusting the values in the water container.

Photo non contractuelle.